| Hangar |
Aircraft |
Category |
Date |
Preview |
| lukebozek1 | Comet Kit #3208 - Aeronca Floatplane | Build | 07-Mar-11 07:18 |  |
| Views : 1621 |
| Major parts and pieces are here. I added a 3/32 spar to the wing, and built up the leading edge slightly. The wing tip is overlapped with 1/32 fo a little extra strength. This is a frail body structure. |
| lukebozek1 | Comet Kit #3208 - Aeronca Floatplane | Build | 07-Mar-11 07:15 |  |
| Views : 1671 |
| Plans are a single cluttered sheet with little notes embedded in some unusual places. I guess this is typical 1945 U-Cut-IT-Out. |
| SteveM | Dumas Kit #1815,DeHavilland DH89 Dragon Rapide | Build | 06-Mar-11 17:32 |  |
| Views : 1497 |
| Moving at the speed of PVA glue meant adding these stringers took quite a while. It is the first time I've added fuselage stringers that didn't rest in a notch so it was slow going marking all the positions then holding them in position till the glue set. |
| John M Oshust | AerodromeRC Sopwith Triplane | Build | 06-Mar-11 16:21 |  |
| Views : 1093 |
| The feathers thru the wings. |
| John M Oshust | AerodromeRC Sopwith Triplane | Build | 06-Mar-11 16:11 |  |
| Views : 1080 |
| Started the slow tand tedious rigging process. |
| John M Oshust | AerodromeRC Sopwith Triplane | Build | 06-Mar-11 16:10 |  |
| Views : 1036 |
| I have the chart listing original wire specs. I tried to vary the material to replicate the original. Plastic coated beading wire was used for the elevator control lines. I is a braided cable like the original. |
