|
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:27 |  | | Views : 762 | | Here is where I changed my mind. I own a couple of 3D printers, and am very good at modeling in 3D software, so I decided to see if I could merge the two. Using as many reference images as I could find, I modeled the nose, radiator and exhausts in my software, then printed them out at very high resolution. This picture is of the cowling inside and out, but I also modeled and printed the radiator, air separator and air ducting to the carbs. |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:24 |  | | Views : 796 | |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:23 |  | | Views : 739 | | Aircraft assembled without fairings |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:21 |  | | Views : 724 | | Aircraft after covering. I used the same materials to cover this as I did my Sea Fury; Top Flight Silk Span and doped with Eze Dope. |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:18 |  | | Views : 713 | | Top of wing. Standard construction techniques. One center section, and two wing outer sections with dihedral on the rib where landing gear attaches. Very straight forward construction. |
| edtherenderman | West Wings Hawker Tempest | Build | 31-Jul-19 15:16 |  | | Views : 731 | | Rudder/Fin and Elevator/Stabilizer. The plans call for a single 1/16” layer, but I built up the surfaces to give them a more scale look. |
|
