| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:58 |  | | Views : 5515 | | The outrigger added.All the wood received several layers of Minwax Polyurethane with lots of sanding in between coats. Final sanding was 600 and 1000 grit paper with a final buff coat of a paper towel, which gives the wood a nice soft sheen. Not too glossy. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:54 |  | | Views : 5485 | | After it was cut out I added looped stitching along the edges so it could get tied to the masts later. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:53 |  | | Views : 5507 | | To give it a curve (these are called "crab claw" sails) I used 3M Spray Mount to affix the paper back to back. White glue caused it to wrinkle. As it was drying I wrapped it around a paper towel roll so it would retain the curve. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Aug-20 10:50 |  | | Views : 5641 | | The real sails were woven matts, about 16" wide. I found a matt pattern on the inter webs and scaled it to my needs. Over a printed base sheet I added each row, overlapping a bit so it suggests the seams where the matts were sewn together. |
|
